00 S10 PICKUP, NO LEFT REAR TURN SIGNAL!!!!!!!!!!!?

Question

I HAVE REPLACED COLUMN SWITCH, BRAKE SWITCH, TURN SIGNAL SOCKET, AND RAN VARIOUS TESTS WITH VOLY METER. ANY SUGGESTIONS. ALSO, WHERE IS THE FLASHER AND TURN SIGNAL RELAY SWITCHES LOCATED. THANKS, SIMON.

Answer 1

do flashers work if they do email me i can tell you what to look for

Answer 2

Have you replaced the light bulb? You probably have a broken wire.

Answer 3

I had the same problem with a 79 Chevy P-U. Right rear signal didsn't work. The bulb was good but no juice to the socket. I had juice coming to the trailer socket for the right signal so I knew the wire was bad between there and the socket on the truck. I took the socket out of the tail light and fished the wires out and found a taped spot in the wire. I took the tape off and some one had used some kind of steel coupling to fasten the wires together and it rusted and the juice wouldn't go thru the rust. I also checked it by sticking a pin or needle into the wire and checking for voltage with a volt meter. I hope this helps, good luck.