2 channel amplifiers?

Question

what brand of amplifiers would sound the best on 2 channels

Answer 1

a kicker or hifonics, but it all depends on how much watts your looking for,

a kicker is good to buy if your looking to power door speakers or a small sub. but i dont recommend it for heavy duty power nothing over 1000watts

a hifonics is more than enough power to get the job done for any loud speakers(subs over 800watts) they produce quality sound with a hard hit!. reply back with the amount of wattage or the amount of money your looking to spend so i can further help you. :)

Answer 2

any amp that is CEA-compliant

CEA-2006 Compliant

On May 28, 2003, the Consumer Electronics Association published standard CEA-2006, "Testing & Measurement Methods for Mobile Audio Amplifiers." This "voluntary" standard advocates a uniform method for determining an amplifier's RMS power and signal-to-noise ratio. Using 14.4 volts, RMS watts are measured into a 4-ohm impedance load at 1 percent Total Harmonic Distortion (THD) plus noise, at a frequency range (for general purpose amplifiers) of 20 Hz to 20,000 Hz. Signal-to-Noise ratio is measured in weighted absolute decibels (dBA) at a reference of 1 watt into 4 ohms. This applies to both external amplifiers and the amplifiers within in-dash receivers.

CEA-2006 allows consumers to be able to compare car amplifiers and receivers on an equal basis. Manufacturers who choose to abide by the new standard are able to stamp their products with the CEA-2006 logo that reads: "Amp Power Standard CEA-2006 Compliant."

which means that the amp has been tested and produces or exceeds the advertised RMS wattage with MINIMUM DISTORTION

(2-channel amps are not the best for subs, just inside speakers- for subs you want a mono block)

here are the CEA-complaint brands

Alpine

Bazooka

Blaupunkt

Clarion

Eclipse

Infinity

JBL

JL Audio

JVC

Kenwood

Kicker

MTX

Pioneer

Polk Audio

PPI

Rockford Fosgate

Sony

Answer 3

jl audio or mtx audio