Question:

2000 impala amp and subs inatallation,?

by  |  earlier

0 LIKES UnLike

i have tryed everything, i need sum advice how to run the power wire to the battery, theres no where to push the wire thru in to the car and i dont have a drill nor do i wanna drill a hole anyone no any easier spots to run it under the hood?

 Tags:

   Report

3 ANSWERS


  1. I'm not sure if anyone has mentioned this to you or now, but you want to look for a rubber grommet to remove. One trick to locating one of these is to follow your hood release cord to the firewall. Sometimes the boot or grommet that it goes through is large enough to pass a wire through if you pull the grommet back and slide the wire through next to the cable. If you cant find one. Just go to a shop and ask them to just run the power wire for you. They may do it at a discounted price.


  2. Run the power cord from your amp kit along the opposite side of the signal cables going to the amp and subs in your trunk.

    I ran my power cable down the drivers side in my civic. Once you get to either side look all up under there and there are these "popouts" allready pre drilled. Pop one of them out and run the wire through the motor compartment close to the top of the hood where the motor is not to your battery.

  3. i do believe i answered another 1 of you question i said drill the hole. well since you dont want to do that and dont have 1. the only other place to do it is run the wire under the car but there is no way you can do this without drilling though unless you want your wires showing and at that they are going to show big time. what you will do is have to pull the wire under the motor and staple it or something close to the exhaust but there is a big change these wires will burn out do to the wear and tear. it will be easier if you just borrow a drill or something.

Question Stats

Latest activity: earlier.
This question has 3 answers.

BECOME A GUIDE

Share your knowledge and help people by answering questions.