2005 dodge ram radio removal?

Question

i have a ram that i want to hook my satellite radio up to, but cant figure out how to remove the trim around the radio. can you help?

Answer 1

Try this site, they have pictures of the removal.

STEP 1. Begin by removing the trim bezel around the radio

and climate control module. Remove the 7mm hex head

s***w located below the right-of-radio air vent. (See

photos # 1 & 2). Open the glove compartment, grasp the

lower right corner of the bezel and pull out gently,

releasing a retainer clip. Continue pulling outward as you

work your hands around the bezel, releasing all eight (8)

clips. (See photo # 2). Disconnect the wiring harnesses to

the bezel and set bezel aside.

STEP 2. Remove four (4) 7mm hex head screws from the

four (4) corners of the radio. Slide the radio out of its

cavity and let it hang down. It is not necessary to

disconnect the wiring to the radio.

STEP 3. Place the Legend VSM against the dash pad in the

upper right corner of the radio cavity. The Legend needs

to be slid to the far right edge of the cavity. Using the

Legend as a guide, mark the location of the three (3)

mounting holes. Set the Legend aside. Using a 5/64” drill

bit and drill, drill three (3) pilot holes, approximately 3/8”

deep at the marked locations. Position the Legend over

the pilot holes, insert three (3) # 8 x 1/2” screws and

tighten. Reassemble the dash in reverse order.

This completes the installation of your Pro.Fit Legend.

5/64” drill bit and drill, # 2 Phillips screwdriver, 7mm nut driver

Pro.Fit Legend, instructions, three (3) #8x1/2” screws, hardware pack

Upper right corner of dash

110305-00

PLEASE READ COMPLETE INSTRUCTIONS BEFORE INSTALLING THIS Pro.Fit Legend.

All instructions assume a drivers seat vantage point. Caution is advised when removing and reassembling

wood or plastic parts of a dash. Applying unnecessary force or pressure may cause a piece to crack or break.

TOOLS REQUIRED:

PARTS INCLUDED:

LOCATION:

Pro.Fit International, Inc.® may not be held liable for any damage to a vehicle before, during or after the installation or removal

of this Pro.Fit Legend. Pro.Fit may not be held liable for any personal injury resulting from accident or improper installation.

Pro.Fit International, Inc.® 1335 Eagandale Court, Eagan, MN 55121, Ph: 651-688-3588 or 800-388-0073 Fx: 651-688-9876

© Pro.Fit International, Eagan, MN 2005

VIEW INSTRUCTIONS & UPDATES

ONLINE @

WWW.PRO-FIT-INTL.COM

PART NUMBER: DG-70-05-L

Dodge Ram (2002-2005)

Dodge 2500, 3500 (2003-2005)

4

3

1 2

Clip Holes

in Circles

7mm Hex

head s***w

The site is in pdf so you will need Adobe Reader for the pictures.

Go to: www.pro-fit-intl.com

click on it, then scroll down to the 29th listing, which will be: Part Number: DG-70-05-L Dodge Ram (2002-2005) Dodge 2500,3500 (2003-2005)

click on it and you will get the pics in pdf format.