Question:

97 Jeep Wrangler error codes 12 and 24 displayed?

by  |  earlier

0 LIKES UnLike

I recently did a beach run and gave it a good wash afterwards, including a quick clean of the engine bay with a high pressure hose. Since I did this I have received two error codes after the 'check engine' light came on; #12 and #24. The engine has also starting running rough, splutters on acceleation and sometimes stalls. Is it possible the water may have affected the o2 sensors or the circuitry.

 Tags:

   Report

1 ANSWERS


  1. Possible, but unlikely.

    Code 12 on any Chrysler or Jeep vehicle simply indicates the battery has been disconnected. Most of the time this code is induced when someone has disconnected the battery as a means to clear trouble codes. This code will clear itself after several successful starts

    Code 24 indicates the Throttle Position Sensor voltage was either above or below the acceptable limit. I wouldn't put a lot of thought into this code because sometimes this code is set when the vehicle is running poorly and the driver keeps his foot into the throttle to keep the vehicle running. There may indeed be a problem with the TPS, but I don't think this is causing the rough running you are describing.

    My first suspicion is you must have got something in the ignition system wet when using the pressure washer. I would try to remove each ignition wire at each end and giving it a shot of WD40. I would then remove the ignition cap and make certain it is completely dry underneath. Do NOT use WD40 under the cap to help it dry. A little compressed air should do the trick.

Question Stats

Latest activity: earlier.
This question has 1 answers.

BECOME A GUIDE

Share your knowledge and help people by answering questions.