Question:

Amp question for 12" Kicker L5

by  |  earlier

0 LIKES UnLike

I just bought 2 Kicker 12" dual 2ohm subs 600 rms. Would a Power Acoustik A2400DB 1800rms*1 at 1 ohm blow them . They are 1400 rms at 2 ohm. Just wondering if they would blow them. I've look online and seen that it is better to get an amp with more rms than the subs and just not power the amp at its max potential that way it wouldn't stress it too hard. Is this a correct amp for these monster L5s

 Tags:

   Report

2 ANSWERS


  1. NO!

    its non CEA-compliant

    you would be lucky if the amp puts out half of the advertised RMS wattage and it would more than likely be distorted (the main cause of speaker damage)

    (i have two L5s hooked up to two KX600.1s-- that's 1200watts RMS and its CEA-compliant like the subs)

    CEA-compliant brands the amps have been tested and produce of exceed the advertised RMS wattage with minimum distortion and the subs can handle their rated RMS wattage also

    here are the CEA-compialnt brands

    Alpine (highly recommend)

    Bazooka (don't like their subs)

    Blaupunkt (don't like their subs)

    Clarion

    Eclipse

    Infinity (highly recommend)

    JBL

    JL Audio (very good but over priced)

    JVC

    Kenwood (don't like their subs)

    Kicker (the best in my opinion)

    Memphis

    MTX (highly recommend)

    Orion

    Pioneer

    Polk Audio (highly recommend)

    PPI

    Rockford Fosgate (highly recommend)

    Sony (don't like their subs)

    if its not CEA-compliant you dont know the REAL RMS wattage and without that info its impossible to correctly match your equipment, heres what can happen

    If you send too much power to your sub, you risk damaging it. The cone of the speaker and the mechanical parts that make it move may break under the stress. Surprisingly, too little power can also damage your subwoofer — in fact, it's actually more common than damage caused by overpowering.

    When the volume is turned up and the amp doesn't have enough power, the signal becomes distorted, or "clipped." This distorted signal can cause parts of the speaker to overheat, warp and melt. Not good!

    You don't have to match speaker and amp wattages exactly. An amp with a higher output than the speaker's rating won't necessarily damage the speaker — just turn the amp down a bit if you hear distortion from the sub and don't run the speaker at extremely loud volumes for lengthy periods. Likewise, you'll be OK with a lower powered amp if you keep the volume down and don't feed a distorted signal to the sub.


  2. I have those same woofers. Are you talking about the amp being 1400 RMS or the subs. Cuz you said THEY are 1400 RMS so that males me think of the subs not the amp. What do u mean?

Question Stats

Latest activity: earlier.
This question has 2 answers.

BECOME A GUIDE

Share your knowledge and help people by answering questions.