Question:

Amplifier for one kicker solo-baric 12"? ?

by  |  earlier

0 LIKES UnLike

I want to know what amp I need for my kicker solo-baric 12"?

Peak: 1500 watts

RMS: 750 watts

High-temp dual 2 ohms voice coil

Frequency response: 20-100 Hz

Sensitivity: 89 dB

Impedance 2 ohms

Peak Power Handling 1500 watts

RMS Power Handling 750 watts

Sensitivity 89 dB

Frequency Response 20 - 100 Hz

Top Mount Depth 6-11/16"

Cutout Diameter 11-1/16" x 11-1/16"

 Tags:

   Report

4 ANSWERS


  1. 750


  2. F*ck Audio"BLING"...that dude is retarted if he recommends them.

    Obviously that dude must not know about car audio...If you want something to really make that sub beat, and is "reliable"...I would recommend a kicker zx750 the 2 ohm series,

    Or a Alpine Mrp-850. Just look for amps that push similar watts to the 2 or 1 ohm loads.

    Hope I helped.

  3. well i have 2 kickers and they both make me deph. i had 1 10" cvr and 1 12" cvr on one mtx thunder amp 400watt at 2ohm. th 10 was run parillel and the 12 in searies drawing 2 ohm total..... kicker can take alot of punishment and still keep kicking LOL.  what i would do is find a class D mono block amp with an output of 1000 watts rms at 1 ohm. bwacuse if you run your kicker in searies then it will draw 1 OHM and usaly an amp that 1000 watts rms would be good for a 1500 watt sub beacuse you should allways have an amp that will push 2/3 the max of the sub at rms. beacuse when you tune the sub you need to ajust the sound with the gain controle. like this turn the volume down then turn the gain of the amp down all the way then turn the music up untell its at the loudist posible then slowly turn up the gain controle untell the sub starts to distort then back the gain down untell it is not distorted and that is wair you should leave the gain. so what this does is set the amp at a level that can be handeld by the sub. and you wont blow it up beacuse it is distorshin and not noise level or power of the amp that blows a sub. beacuse you can controle both noise level and power with the gain controle.

  4. Your looking for an amp that puts out 750 RMS. Since you have DVC and the coils are 2 ohms each your going to want to wire them in parallel to produce 1 ohm.

    For the amp i recommend the  Audiobahn A8001DT.

    http://www.sonicelectronix.com/item_1640...

    That amp puts out 800 RMS at 1 ohm so that should run your sub really well.

    hope this helps.

Question Stats

Latest activity: earlier.
This question has 4 answers.

BECOME A GUIDE

Share your knowledge and help people by answering questions.
Unanswered Questions