Any ideas why im not getting spark?

Question

I am using a ms2 v3 with an accel 300 box and coil. NE1 from ecu pin out is hooked to ING from megasquirt. Pin 36 from ms is connected to white wire from accel box. Anyone who knows anything about this help would be appreciated.

Answer 1

Here's a trouble shooting guide:  http://www.accel-ignition.com/pdf/TS_300...

When you hook up the ground, it needs to be on bare metal, you may need to sand off the paint in order to get a good ground.

Answer 2

Contact accel teck support>They should help you trouble shoot why no spark>

Answer 3

???????

Answer 4

I am very impressed with what you have taken on, I have looked into building a fuel injection system using a Megasquirt for some time, but just haven't had the time to do it.  What type of pickup are you using and what type of application is this on?  If it is a V-8 are you using a hall effects system, an optical etc.  I need a little more information.

Answer 5

It literally sounds like you didn't follow directions. Read em again.