Question:

Can I fix my own projector bulb for an Epson EMP-730 projector?

by  |  earlier

0 LIKES UnLike

Can I fix my own projector bulb for an Epson EMP-730 projector?

 Tags:

   Report

1 ANSWERS


  1. yes. on the bottom of the unit is where you will find the bulb cover.

    1) Turn off the projector power, wait

    for the cool-down period to end,

    and then disconnect the power

    cable.

    The cool-down period lasts for about 45

    seconds. The actual time will vary

    depending on the external air temperature.

    2) Wait until the lamp has cooled

    down, and then remove the lamp

    cover from the base of the

    projector.

    It takes approximately one hour for the

    lamp to cool down by itself after the cooldown

    period has finished.

    While pressing the two hooks, pull the

    lamp cover up to remove it.

    3) Loosen the two lamp fixing screws.

    Use the screwdriver that is supplied with

    the spare lamp or a Phillips screwdriver to

    loosen the two lamp fixing screws that are

    securing the lamp to the projector

    4) Take out the lamp.

    Hold the lamp by the two recesses on the

    side to lift it up and out from the projector.

    5) Install the new lamp.

    Hold the lamp so that it faces the correct

    way to fit into the projector, and then

    insert the lamp until it clicks into place

    and tighten the two fixing screws.

    6) Install the lamp cover.

    Insert the two cover tabs into the projector,

    and then press the other side of the lamp

    cover until it clicks into place.

    Bulb replacment is on page 76

    http://www.epson.co.uk/support/manuals/p...

Question Stats

Latest activity: earlier.
This question has 1 answers.

BECOME A GUIDE

Share your knowledge and help people by answering questions.