Cost of cutting a shaft for a driver?

Question

How much would i cost me to cut 3/4 of an inch of my driver?

Answer 1

5 dollars steel  7 dollars graphite . the steel can be cut by your self , or a friend with tubing cutter . the graphite also can be done by yourself . just place 3 wraps masking from top of shaft doen teo inches , this is to protect fibers from weaking , use fine tooth saw . cuts like butter . if you go to high end golf shop . the above gentlemen are correct . a small repair shop will do it for the 5 to 7 dollars . if you buy the grip from them . thier grips will be cheaper than large retail store . thanks

Answer 2

about ten dollars for labor and then the price of a new grip

Answer 3

I think it's about the same for all clubmaker and custom fitters.   Any shaft labor is around $15 to $20.