Cruise control info required on Dodge?

Question

I've a 96 Intrepid 3.3 and the PCM has a 60 pin layout.

If anybody has any info regarding the colours of the wires that go to the transmission control module=PCM from the Cruise Control circuit and the PCM's pin layout info I'd be grateful for any info schematics or diagrams or just the pin and colours of wires...By the way I'm getting code 77= either the cruise control relay isn't working or the 12 volt regulated feed isn't being detected and the dash light comes on saying cruise control when I push the switch cruising on hwy but the cruise control fails to kick in.Many thanx to all that reply.

Answer 1

Bob usually when you have a cruise problem there is a good Chance it could be the clock spring not that I would just change it but if you also had other connected symptoms like an air bag light on (driver squib) or something like that I would try it also if your cruise mounts under the battery look for damage due to bat acid. I don't know if this applies to you, but good luck.

Answer 2

Here you go, I have included the test procudures, and connector diagrams.

http://s153.photobucket.com/albums/s228/...

http://s153.photobucket.com/albums/s228/...

http://s153.photobucket.com/albums/s228/...

http://s153.photobucket.com/albums/s228/...

http://s153.photobucket.com/albums/s228/...

http://s153.photobucket.com/albums/s228/...

http://s153.photobucket.com/albums/s228/...

http://s153.photobucket.com/albums/s228/...

http://s153.photobucket.com/albums/s228/...

http://s153.photobucket.com/albums/s228/...