Denon AVR 2106 Protect Mode (followup). Checked R184 10 ohm resistor and it checked out @10.7 so

Question

Checked R184 10 ohm resistor and it checked out @10.7 so that looks OK.
The DC voltages for R 145 and R146 look way out of wack. When measured
against chassis ground R146 read -28.49 on one side and +3.28v on the
other. Similarly R 145 measured +3.27 on one side and + 35.6v on the
other. I did check the output transistors a week or so ago. When I
compared the ohm readings one against the other they all were similar.
I assumed that they wouldn't all fail at once so I discounted their
failure. I only have the schematics for the 2106 not the complete
service manual. Since the schematics don't have the voltage regulator
model numbers I need to ask you for them and/or the Denon part numbers.
I assume they will be unique to Denon. Otherwise I could go generic.
Please advise and thanks very much for your input. It's what I was
looking for.