Direct Tv Remote?

Question

how can i make my direct tv remote work my tv?

Answer 1

by pressing MENU on your remote  then SELECT on Settings,

Setup in the Quick Menu, then selecting Remote from the left menu.then you SELECT tv then the brand you will see some codes that you can use to do the following

1. Slide the MODE switch to the TV position.

2. Press and hold the MUTE and SELECT keys at the same

time until the green light under the TV position

flashes twice, then release both keys.

3. Using the number keys enter the 5-digit code for your

brand of TV. If performed correctly, the green light

under TV flashed twice.

4. Aim the remote at your TV and press the PWR key

once. Your TV should turn off. If it does not turn off,repeat steps 2,3 and 4, trying each code for your brand

until you find the correct code.

If you were unable to find the code for your brand of TV or

component, you can try a code search. This process may

take up to 30 minutes.

1. Turn on the TV or component. Insert a tape or disk if

applicable.

2. Slide the MODE switch to the TV, AV1 or AV2 position,

as desired.

3. Press and hold the MUTE and SELECT keys at the same

time until the green light under the selected switch

position flashes twice, then release both keys.

4. Enter 9-9-1 followed by one of the following fourdigits:

COMPONENT TYPE COMPONENT ID #

Satellite- 0

TV -1

VCR/DVD/PVR -2

Stereo -3

5. Press PWR, or other functions (e.g. PLAY for VCR) you

want to use.

6. Point the remote at the TV or component and press

CHAN up. Repeatedly press CHAN up  until the TV or

component turns off or performs the action you

selected in step 5.

NOTE: Every time CHAN up is pressed the remote

advances to the next code and power is transmitted

to the component.

I hope is will help you!

Answer 2

I've had Direct TV for years. If you cant program the remote based on the menu then you are probably out of luck. From my experience the less popular brand or new model TVs are not in the receiver's programing. I have a TV now that the master power button wont control the TV, so I have to slide the device switch over to the TV control to power the TV on or off, very annoying. My father has a TV with the same type of problem. You can call DTV and talk to a tech, if they cant help you then you're probably in the same boat as me. Good Luck.

Answer 3

press I think is a button that says tv....then a code there is a code (it depends on the tv you have) but defiently call their customer service and keep that code just if in case that happens.....is quick just call and you'll know in less than 5 minutes..........plz keep the code soemwhere so you'll remember it ;)

is simple is pressing a button and at the same time a code.....is simple but call them! They'll help ;)

Answer 4

u have program da key for dat to happen