Do halo hoppers stop balls from breaking

Question

i have just a stock hopper for my spyder tlr, but i have a rocking trigger and an acs bolt but i keep breaking lots of balls. so what do i have to do or buy to stop balls from breaking, and what is happening that makes the ball break

Answer 1

For starter check your ACS bolt. You bolt could be install improperly or may be defected. Start by removing your hopper from your feed neck so you can see your bolt. When your marker is in the charged(**chocked whatever**) position. Do you still see your bolt. Your bolt can be so far forward that it's stopping the ball from fully

loading. Causing chopping. Yes the ACS bolt is spring loaded and is

design to bounce back if a paintball is not properly loaded. But nothing 100 percent...

2... Your Verlocity my be to high. Turn it down and see what happens...

3... Your paintballs may have gone stale. Try firing some frest paint.

4... Barrel "may" be dirty

5... Bore size(**barrel size**) Barrel may be too small..

6... May just be the hopper. The stock gravity hopper has a TOP feed rate of 6 or 7 ball a second...***thats if you're shaking the h**l out of it while firing... lolz***

You have a Rocking right... I also have a Rocking trigger on my Spyder VS3. You'll be able to shot ropes with that trigger. And a stock hopper not gonna cut it. You're going to want something to feed as fast as or faster than you're firing...

Answer 2

the reasone why the balls are breaking is you are shooting faster than the balls are being fed by the hopper so yes if you get an electronic hopper it will fix the prob. but you dont need a top of the line halo