Do yall think an power acoustic1920 2 channel amp bridged will work for an 15 inch kicker L7 in an ported box

Question

its 1920 watts 2 ohm stable what should i do

Answer 1

NO, NO, NO, and NO

why would you get a high quality sub and mess it up with a flea market amp

that amp is so overrated that you would be lucky to get a third of the advertised RMS wattage and it would more than likely be distorted

you need to stick to CEA-compliant companies which means that the amp has been tested and produces or exceeds the advertised RMS wattage with minimum distortion

with non CEA-compliant amps you have no idea of the "real" wattage so its almost impossible to match your subs to them properly, this is what can happen

If you send too much power to your sub, you risk damaging it. The cone of the speaker and the mechanical parts that make it move may break under the stress. Surprisingly, too little power can also damage your subwoofer — in fact, it's actually more common than damage caused by overpowering.

When the volume is turned up and the amp doesn't have enough power, the signal becomes distorted, or "clipped." This distorted signal can cause parts of the speaker to overheat, warp and melt. Not good!

You don't have to match speaker and amp wattages exactly. An amp with a higher output than the speaker's rating won't necessarily damage the speaker — just turn the amp down a bit if you hear distortion from the sub and don't run the speaker at extremely loud volumes for lengthy periods. Likewise, you'll be OK with a lower powered amp if you keep the volume down and don't feed a distorted signal to the sub.

here are the CEA-compliant brands

Alpine  

Bazooka  

Blaupunkt  

Clarion  

Eclipse  

Infinity  

JBL

JL Audio  

JVC

Kenwood

Kicker  

MTX  

Pioneer

Polk Audio

Rockford Fosgate  

Sony