Drive belt on a peugeot 206?

Answer 1

loosen the allen s***w on the small bottom pulley as veiwed from the front right side cut or prise off old belt make a drawing of the belt route first as it can be hard to work out how to refit it if you dont.Route new belt as per your drawing leaving the air compresor pully to last then the belt can be pulled over the last pully.It will be a bit tight this is because tension is made by the fixed pully.When belt is in place take up the slack with a small sqaure drive socket/key located in the pully with the allen key then tighten the allen key bolt  whilst holding tension on the pully.Job done.I found putting the car on ramps was a must.

Answer 2

i would like to cahange a utilaty belt(alternator ) on my 206 is it easy, if so where do you start