I have ordered and replaced the footswitch mechanism for a Kirby G4. I had it running while pushing in safety switches before re-assembling. However, when I had put the handle back on it would no longer run.I am looking for a confirmation on the wiring in case I have switched the wrong ones. I could understand any instruction about references to wire connection on the footswitch such as the A (lower) or B (upper) male connectors, or the slot to the left of those.With reference to the origin of the wires that plug into the footswitch, I would understand "long" and "short" wire originating out of the top of the vaccuum , and "wire originating from below the footswitch" and "wire originating from 45-degree angle male connector near pulley".Or as an alternative, an image of wiring diagram would be helpful. THanks for any input
Tags: