HOW DO I BLEED A CLUTCH MASTER CYLINDER ON A MAZDA 626 .

Question

it is a 4 cylinder 1998

Answer 1

fill master.. jack up car crawl under it most time driver side have someone pump the pedal a few times and leave the bleeder off and retighten.... once or twice should do it

Answer 2

first put the car on ramps NOT on jacks.

second have somebody pump the clutch pedal or you can use a bleeder pump.

third bleed at clutch slave first - have the person pump clutch pedal 3 or 4 times then hold pedal down to the floor and open clutch slave bleeder valve for less than 3 seconds. pump the clutch pedal 3 or 4 times and hold pedal down again to bleed again.

fourth - pump pedal again 3 or 4 times and hold it down and open bleeder screen at clutch master cylinder or open where line come in at clutch m/c. repeat this step couple times.

bleed entire process couple times -

repeat step 3 and finish off at clutch slave not at clutch m/c.

tip - after bleeding clutch m/c after first attempt...take handle of s***w driver and slighty tap on clutch m/c housing and you can see air bubble coming up.

hope this help youl