Hot taps have all stopped working

Question

I changed a washer in bath mixer taps and now all hot water in the house has stopped nothing comes out. there's water in the tank tho ???

anyone know what I've done wrong

Answer 1

If You Cant Fix It Yourself, Get A Plummer :)

Answer 2

probally an air lock

To overcome this, attach a length of hosepipe to the affected tap and connect the other end to a working direct feed tap. In most cases this will be the cold tap on the kitchen sink.

Open both taps to allow the pressure of the mains water to force the air back out of the pipes. Leave to act for several minutes, then turn off the air locked tap first.

It may be necessary to repeat this a few times to release the lock and allow water to run properly.

When finished, undo the hose from the higher of the two taps, before releasing the lower and allowing the water in the hose to drain into the sink.

Air lock at more than one tap

If more than one tap appears to be airlocked, clear it from the lowest one.

With cold water pipes from the attic cistern, it may also be possible to blow out the airlock if the above method fails.

Push a length of hose into the outlet pipe within the tank. Open the tap at the other end. Blow through the pipe to dislodge the lock.

Draining down to remove an air lock

As a final resort method, drain the system down. Turn off the water feed and open all the taps to drain the water.

Close all taps until they are about a three quarters closed. Turn the water supply back on.

Adjust them all until a light, even flow of water is achieved.

Now go round opening them one by one to the half-open position, starting with the lowest and working upwards.

Repeat at the three quarters open position. Once all air has been discharged, turn all taps off to a point where there is only a minimal flow.

Finally, close them all before checking the operation of each in turn.

Answer 3

You've got an air lock in the hot pipe.  Join the kitchen taps together with a piece of hose (or it you've got mixer taps, force a piece of rubber across the end of the spout) and turn them both on full. The mains pressure should force the airlock out of the expansion pipe.  Don't do it for too long or the loft tank will overflow.