How Do I Mount a License Plate to the Front Bumper of a 2007 Jeep Wrangler X?

Question

How Do I Mount a License Plate to the Front Bumper of a 2007 Jeep Wrangler X? There are no pre-existing holes... Thanks

Answer 1

I wouldnt say this if it was any other vehicle. But since its a Jeep i would suggest that u get a winch with a roller fairlead, and then get a license plate bracket for the roller fairlead. its like killing 2 birds with 1 stone. now u wont have to worry about getting stuck.

Answer 2

If you look realy close you'll see four small indentions in the bumper, this is where your license plate will s***w to. Find a drill bit smaller than your screws and drill the first hole and then make sure all of the other holes will line up with your plate. Drill the other holes and s***w it on.

Answer 3

Go to the dealer and go to the parts dept. There should be a bracket they have or can get that will fasten to the jeep using the bolts and/or holes in the bottom of the bumper etc. Then you can mount your plate to that. It shouldnt cost much to buy. If there is not a bracket avalable have them show you how you put the plate on the jeep.........Hope this helps...........UJN