How can i get my skateboarding bearing to get faster?

Question

i have reds....

Answer 1

OK all you need to do is get them "broken in" or you can loosen them that will make it go faster also. skate on

Answer 2

buy new ones

Answer 3

for REDs..this was you should do..its kinda like mod upgrade for you abec upgrade..take off the bearing shield..only take em off one side..this can be done easily wit a small flat s***w driver..go down to the hardware store..get a small tube or tub of Lithium High Temp Grease..and some solvent to clean your bearings-gasoline,thinner turpentine..

1)after taking off the shields from your bearings..put em in a plastic container..pour in the solvent..let em soak in for a minute..give it a shake or a stir to draw out the particles trapped in the bearing cage..do this twice if needed..once cleaned dry em wit a clean cloth..

2)next apply a small amount of the lithium grease into the bearing race,cage and bearings..if your grease comes in a tube this would be less messy but if you can only get em from a tub..get a small syringe remove the needle,load up the grease in the syringe.

3)next put the shields back on..or if you wish leave em off..

this would make your bearings roll faster..but every once in a while repeat the routine..this would prolong your bearing and save you some cash for a new board..

Answer 4

clean them...search on google about how to clean your bearings.