How do I program my keyless entry remote for my 2000 Pontiac Firebird?

Question

How do I program my keyless entry remote for my 2000 Pontiac Firebird?

Answer 1

you have to go to the dealer

Answer 2

IMPORTANT:

Programming of the transmitters cannot be done simultaneously. The first transmitter must be completely done before the second transmitter is programmed.

When you replace a lost or damaged transmitter, program all of the transmitters. The first transmitter code that you program will always be in four memories unless additional transmitters are programmed.

Program the remote keyless entry system for one vehicle at a time. If you program two or more vehicles and the vehicles are close to each other, one transmitter could be programmed to more than one vehicle.

The transmitter may not communicate or becomes out of synchronization with the receiver if any of the following situations occurs:

The transmitter battery is disconnected.

The vehicle battery is disconnected.

The transmitter and the vehicle are separated for 2 weeks or more.

The receiver is disconnected.

Perform the synchronizing procedure if the transmitter does not communicate or becomes out of synchronization with the receiver. If the transmitter and/or receiver are replaced, perform the following programming procedure:

Turn the ignition switch to the OFF position.

Remove the RADIO fuse (#17).

Cycle the ignition switch from the OFF position to the RUN position 3 times within 5 seconds . The body control module (BCM) will verify entry into the programming mode by performing the following actions:

3.1. Locking both of the doors

3.2. Unlocking the drivers door

3.3. Releasing the rear compartment lid

Press and hold both the LOCK and UNLOCK buttons on the first transmitter for approximately 15 seconds . The following actions will occur:

The BCM will confirm that the transmitter code is programmed by performing the following actions:

Locking both of the doors

Unlocking the drivers door

Releasing the rear compartment lid

Any transmitter code that was previously programmed is erased.

The BCM is programmed to the transmitter.

If you are programming the BCM to match additional transmitters, repeat step 4. You may program up to 4 transmitters. This must be done before the RADIO fuse is reinstalled.

Place the ignition switch in the OFF position. IMPORTANT: The remote keyless entry system will not be operational if the program input line (RADIO fuse) is open.

Replace the RADIO fuse (#17).

If at any time it is necessary to restart the procedure, turn the ignition OFF and proceed again with step number 1.