Question:

How do I remove my bathtub?

by  |  earlier

0 LIKES UnLike

I need to replace my bathtub and it is made of plastic. It has three plastic cheap wall panels, it is NOT a solid one piece. Where do I begin? It is in a mobile home.

 Tags:

   Report

5 ANSWERS


  1. use a sledge hammer. but also wear safety glasses


  2. you cool look for information at places like http://www.bathtubworld.com to find out what to do.

  3. if you  are just taking the tub out to throw it away  get your reciprocating saw out and cut it up into managable pieces just be careful off the waterlines and walls connecting to other rooms .good idea to turn the water off incase you nick a pipe or something

  4. use a sledgehammer and have some fun. otherwise use  a saw.

  5. 1. Locate Shutoff Valves and Turn Off Water. Once you have all of your supplies gathered, it is time to move to step one. Turn off the water. Disaster would result if you tried to remove your old tub without turning off the water. If the person who built your house was feeling kind, they left you an access panel to the shutoff valves, and this job will be fairly simple. Check the wall behind the plumbing. It may be in a closet or in an inconspicuous place in a hallway. If the tub is located on the first floor and you can't find an access panel, check the basement. The shutoffs may be located under the tub and you will be able to access them from your basement ceiling.

    The worst case scenario is that you will have to break a small hole in the wall to turn off the water. If you do have to do it that way, try to do it from the back side in a closet and then go to the extra trouble of installing an access panel. You will be saving yourself more work down the road if you ever have a leak inside the wall.

    2. Remove Handles and Spout. After you have the water turned off, remove the handles and fill spout. The spout should just twist off. You can probably do it by hand, but if it's tight, use the wrench. If you're going to re-use the spout, pad the jaws of the wrench with a rag. If not, then twist away.

    Once the spout is off, you can move to the handles. Most are held on with a set s***w. These can be removed with an allen wrench. With the handles and spout gone, you are now ready to remove the tub.

    3. Take Out the Tub. One of the biggest challenges to installing your own tub is maneuvering your old tub out and your new tub in. Bathrooms aren't typically the biggest rooms in the house, and the logistics of getting a large heavy object in and out of the door can be a little complicated. If you have an old cast iron tub, or if you purchased a new cast iron tub, you probably aren't strong enough to lift it up over your head to get it out of, or into, the back corner of the bathroom.

    Most of the time, removing the toilet before you start will give you a lot more room to work and will keep you from having to lift a very heavy tub up and over. Sometimes it is necessary to remove the vanity as well. This will be true if your vanity or toilet is right up against the tub. There simply won't be enough room to pull it out from the walls that it is sandwiched in between.

    Once you have the toilet removed, or are confident that you have room to work, use the pry bar to break the old tub free from the floor. If you are going to save this floor, then take care not to damage it when you are using the pry bar. Put a towel underneath any fulcrum point and make sure that, if the floor is ceramic, you use a thin piece of wood as a buffer between the floor and the bar to insure that the tile does not crack. After the tub is free, you should be able to pull it straight out.

Question Stats

Latest activity: earlier.
This question has 5 answers.

BECOME A GUIDE

Share your knowledge and help people by answering questions.