How do i adjust the toe in on a cam-am DS90X?

Question

How do i adjust the toe in on a cam-am DS90X?

Answer 1

Like on a car, there are steering arms. To adjust the toe-in on your atv, you want to make sure all your basic front-end fasteners are snug tight, then make sure you are on a flat and level surface with the handlebars COMPLETELY straight. Then you want to grab your adjustable wrench and loosen off the tie-rod nuts (Located on the rod, and its not the large brass type piece). To make sure they are correct, measure the distance between the front of the two tires, and you want it to be the same as the rear to be aligned properly. Then adjust the bar by twisting it in or out so the wheel straightens out. Repeat this on the other side. And don't forget to re-tighten your tie-rod nuts. Then measure your alignment until correct. A dealership would be best suited for this. Good luck