How do i connect Two (2) dual voice coil subs to a 2 channel amp?

Question

I have the Power Acoustiks Fubar series some information about the subs : Dual 4 ohm voice coil

* 1800 watts power handling

* 800 Watts RMS

* 200 oz. magnet

* 2¡± BASV voice coil

* SPL 91 dB

* Fs: 36 Hz

* Vas: 1.91 cu.ft.

* Qms: 5.71 ? Qes: 0.502 ? Qts: 0.462

* Xmax: 0.4"

* Tuning: 40Hz

* Port Size: 4¡±(dia)x8.75¡±(length)

* # of ports:1

* Mounting Depth: 6.25¡±

I just would like know to the the proper way of connecting them, remember my amp is only 2 channels........ i had a 4 channel amp. but im guessing i had it connected wrong and, well, poof... that was 800 watts 4 channel amp... now i have a different amp, same watts 800 just its 2 channels..... Thanx in advance...Any tips or ideas or any info that can help would be greatly appreciated... thank U ^_^

Answer 1

Here is a link to a diagram that make it easy to understand. Use wiring option #1 for dual 4ohm voice coils wired in parallel. Just run a wire between the two positive terminal on the back of the woofer and do the same for the negatives. Then connect the woofer like to the amp like normal.

Answer 2

well if you have a 800 watt amp that is 2 channel then no worries! Thar are 4 prongs on each sub so what you do is run a wire from the (+) side on one side of the sub and connect it to the (-) on the other side. now you have only 2 prongs left and you run those to the amp and do the same to the other sub.

Answer 3

wow so many information.....

sorry i really don't know...

i think you should see the manual...

or hire someone...