How do i install a shifting cable on a omc outdrive?

Question

I INSTALLED A SHIFTING CABLE ON A OMC CORBRA OUT DRIVE WHEN I INSTALLED THE OUT DRIVE BACK ON THE STERN I STAYED IN REVERSE WHEN I SHIFTED.

Answer 1

I hate to do this to you but you are going to need to take the out-drive back off because there is a specific measurement you

must do in order to get it to shift properly.You will need to get an OMC manual to get the proper instructions to do this.If you

do not get this set-up done before you install your drive,you will never get it to adjust properly.I hope this will help you and good luck.