How do i install motocross handlebar grips?

Question

dirt bike, renthal handlebars, 909 grips

Answer 1

i kno it sounds weird but put hairspray on it i kno it sounds wierd but try it well it worked for my yfz 450

Answer 2

There are a couple of ways to do this.  

You can glue them on using bar grip and most places sell this although it tends to be a bit messy. It is also a bit more difficult to get the ends off if you have to replace them again.

If you don't want to use glue you can get a compressor and put the nozzle into the corner of the grip to blow it up and while doing that this allows you to push the grip onto the bar.  Once you have it on then you can use a stainless steel fine wire to wire the grips in place. It's the best way to keep them on for racing.

Make sure to keep bar plugs in the ends of the bars also.

Answer 3

Easiest answer ever.

Hair spray. Grab your sis or moms can of hair spray, put a liberal amount on the bar and the grip will slide right on, when it dries it will be tacky enough to hold the grips firmly in place.

Answer 4

you cut off ur other ones and put them over the bars

Answer 5

It seems impossible if you have never done it...This isn't fitting?!?!

Personally I spray some good old spray paint in the grip to lube it up, so it can slid on. Then once it settles it acts as a glue..2 IN 1!!=]

Just push very hard, and make sure they are the right size of course..Twist, and push...

And fill it up with spray paint

I would say spray for about 2 1/2 seconds in each grip! =]

Answer 6

put it on with (normally it comes with the handles) glue on the bar and in the grips... slide them on... then get a 4 thin steel wires to wrap 2 on each end of the bar... trust me its the only way to keep them from sliding... and the pros do it just check the bars out when they are on tv