How do i replace the pipe that goes from my kitchen sink to the sewer? ?

Question

Its clogged and when i looked at the pipe, it was leaking because there were little holes in it. I want to replace the leaking pipe to a new pipe. I was just wondering how to change it. I tried to take it off but it was very difficult.

Answer 1

if you have to ask, it may be time to pay a plumber.  

being the pipes are corroded with small holes as you stated, the pipe is well deteriorated and will probably snap off and you'll be stuck with more problems and wind up calling the plumber anyhow.

"a man has to know his limitations".  >>>>> clint eastwood<<<<<

Answer 2

Go to the askmehelpdesk and register. It's free. Take some pictures and ask your question in the plumbing category and they will help you.

Answer 3

If you have a cast iron sewer pipe you can't because it is stuffed with oakum and leaded in which requires torches or a lead pot.

Answer 4

Karma, this can be a really messy job, so unless you're really committed to doing this yourself, you might want to hire a plumber or a good handyman.  I'm bettin' you're talking about the drain line that comes off the bottom of the sink and either goes into the a pipe in the wall or in the floor.  Most likely this was a chromed brass pipe that has now turned to just the chrome remaining and no brass left inside.  It's a common problem. First remove the trap assemblyl, that's the "J" shaped piece of pipe that's attached to the pipe that either goes into the wall or the floor. Put a small bucket under it when you loosen the two nuts, as it will leak the water out that's standing in the trap.   If you're starting from the strainer baskets then you'll need to remove the nut that holds the pipe up to the bottom of the basket, taking note when you remove the pipe, of the type of gasket that's inside the pipe.  Remove both nuts and the pipe will be loose, with the trap off, you should be able to remove all the pipes and throw them away.   It would be good to take a picture of the whole assembly before you start to dismantle it so you can remember how it goes back together.   Also, once you have it all apart, take the picture to the hardware store and tell then you want a PVC replacement system for the drains in the photo.  They should be able to get you what you need.  Have plenty of paper towels or rags around while doing this project.