How do i set up my throttle and brake servo on my hyper 7?

Question

How do i set up my throttle and brake servo on my hyper 7?

Answer 1

First take off the throttle and brake linkages, then set your servo arms to neutral position, including the trim settings on the remote. Fit back on the linkages maikng sure for the throttle, the carb is closed (look through the air intake) and the engine idles consistently.

For the brakes, set it so at neutral the chassis rolls without resistance. Then brake on the remote and make sure the brake callipers on the car are biting strongly. Your brake setting can be adjusted with the two screws either side of the brake calliper.

Answer 2

if you have a look on a proper website it is bound to say.but wat do you want seeeting up,its usally a load of screws and stuff