How do install a line output convert?

Question

i want to install a line out converter in my 2006 chevy avalanche. i was wondering what would be the easiest way to go up on doing this?

Answer 1

just depends on were you put your amp just wire it close the your amp but the converter is connected to your speaker wires  

Answer 2

The easiest way is to extend speaker wires from the rear speakers or from behind the deck.  If you look up the wiring diagram on the web you will know which ones are pos and neg.  They only problem you could run into is that if the truck is equipped with a higher end factory system, one with amps for the speakers.  If it does have amps then the signal could potentially be changed before the speaker.  Meaning it might have some equalization or cross-over done to it.  Make sure you hook up the LOC before any of this equialization or you will not have full range going to the amp.

If your LOC has a remote turn on then you can send that wire right to the amp.  If not then you will need to make a remote wire from an acc on source in the car.