How do you get tire rubber off of cement drive way

Question

we have a cement drive way and some body burned rubber with there car leaving tire marks how do you remove the rubber mark?

Answer 1

Go to your local hardware store and get a can of brush on stripper and a brush. Brush on the mark, let set for a few minutes, wash off with water ( Also know as Grafitti remover )

Answer 2

Take a couple shovel loads of sand and put it on on the rubber marks. Take a street broom and and scrub the sand over the rubber marks with the broom. This should remove the rubber from your driveway. Hope this helps.

Answer 3

Try a propane torch heating it up then wire brush it up but do a small test area first to see if this too could leave a mark.

Answer 4

make the person who did it come and remove it

the easiest way would be to pressure wash it.