Question:

How do you install an amplifier into the boot of a car for use with a subwoofer?

by  |  earlier

0 LIKES UnLike

I have a 2 channel amp and I do not know how to install it!! Can anyone give me a step-by-step guide on how to install it?

 Tags:

   Report

1 ANSWERS


  1. You must first buy a car stereo wiring kit. First you must run a power wire from your battery. Note: before working on your vehicle always remove the negative terminal for the battery. this must go through your firewall so you may need to drill a hold or find a grommet with enough free room to push through. once the power is back there you can look around in the general area for a s***w you can use as a ground. put a o-ring connector on the ground wire and run it to the amp. from your stereo head unit you need the blue wire ran back along with the 2 audio jacks. this is all located at the back of the head unit. once all these wires are ran back and connected you need to run a short 2 pair wire for you sub (if your only installing one sub(1, 2-pair wire per sub unless wired in parallel)) once all connected put the terminal back on the battery, insert the fuse and test the system. have it all turned down at first and slowly turn it up to ensure proper wiring.

    Good Luck

Question Stats

Latest activity: earlier.
This question has 1 answers.

BECOME A GUIDE

Share your knowledge and help people by answering questions.