How do you reset a previously used clearblue easy fertility monitor?

Question

How do you reset a previously used clearblue easy fertility monitor?

Answer 1

According to the website....

http://www.clearblueeasy.com/index.php?p...

here are the instructions:

http://www.clearblueeasy.com/pdf/CB_FAM_...

How to Start Using Your Monitor Again

It is important that you read the following notes first.

• Check that you are still suitable to use the Clearblue® Easy Fertility Monitor (refer to pages 5 and 6).

• Reprogramming your Monitor erases all the previous information stored about your cycles.

• The procedure is not reversible - previously stored information cannot be retrieved.

• You will need a Test Stick to reprogram your Monitor.The Test Stick can be previously used or unused.Therefore, you may wish

to save a used Test Stick from your last cycle for when you are ready to reprogram your Monitor.

• Ensure working batteries are in your Monitor prior to reprogramming (refer to page 8).

Reprogramming Procedure

1. Ensure your Monitor is switched off.

2. Insert a Test Stick into the Test Stick Slot, checking the position carefully, as there will be no symbol to tell you that the Test Stick

is correctly inserted.

3. Press and hold the m Button while you complete steps 4, 5 & 6 below.

4. Press the On/Off Button to turn your Monitor on.

5. will be displayed.* Continue to hold the m Button and leave the Test Stick in position.

6. After approximately 15 seconds, all symbols on the Display Screen will be shown. will again be displayed.

The m Button can now be released and the Test Stick removed.

7. You should see the following symbols on your Display Screen ‘-- m.’Your Monitor is now reprogrammed and ready for use.

*If is not displayed, the Test Stick is not inserted correctly.

TOLL-FREE HELPLINE 1-800-321-Easy (3279)

i hope this helps!  good luck.

kathy, RN, MSN

Answer 2

If you have purchased a used CBEFM or if it has been a long time since you have used yours, you may want to reset the memorybanks to a clean slate. I got these off of the internet a year or so ago when I bought mine. Hope this can help someone.

Please read all instructions over before attempting to re-set the monitor!

1. With the monitor OFF, place a clean unused test stick with the cap on (remove plastic cap from one end and snap it onto the other end of stick) in the test stick slot of the monitor.

2. *Make sure it snaps in.*

3. Press and hold the "m" button. Continue pressing the "m" button while turning the monitor ON.

(NOTE: Do not take finger off "m" button until these directions say to do so.)

4. It will show you the "remove the test stick" sign. (a flashing test stick with an arrow pointing right) Continue pressing "m".

5. Keep pressing the "m" button and in about 20 seconds, you will see a screen full of symbols. The screen will look as if it is going crazy and will be full of pics.

6. Remove the test stick first and then QUICKLY release your finger from the "m" button. All of the memory should be wiped out.

7. Your screen should display a flashing "m" and one or two dashes. If it does not, it will probably show a "1" and a non-flashing "m". If it does, then you need to repeat the process so it shows the flashing "m" and dashes.

8. Start using the monitor on CD 1 as per the instruction booklet.

Straight from the internet itself, good luck, baby dust to you.