How fast will a 01 yamaha warrior go that has been jetted out and has been bored over.50 and has a cobra pipe?

Question

How fast will a 01 yamaha warrior go that has been jetted out and has been bored over.50 and has a cobra pipe?

Answer 1

it will go the same top speed (fast) as the stock one. until you change gearing it wont going any faster unless you are turning more rpm's.  if you raised the rpm's a bit it may go 2 mph or so faster. you will make more power and accelerate faster. but speed will be basically the same.

Answer 2

1/4 mile time is around low 10 seconds

Answer 3

Well, while you have done some engine work, what you will find is that the top speed will basically be unchanged.

You have a rev limiter, as well as stock gearing, so, although you will get there faster, I dont belive that your actual top speed will increase by anymore than 5 miles. If that.

Answer 4

assume dude!

that is one bad $%# machine

70 mph man

Answer 5

I'm guessing around 13 sec at 100mph in the 1/4. Not particularly fast. Beside overboring .5 is HALF AN INCH. Their won't be much left in the cylinder walls. Pipes and jetting make noise and thats about all. Want to go faster, buy a bike rated for speed.

Answer 6

55mph

Answer 7

Not a lot faster.

Would be cheaper to buy a Blaster with a 240 bore kit.

Answer 8

doesnt matter,its just a fantacy in your head anyways,save your paper-route money and youll buy a bike someday

Answer 9

160 mph terminal velocity if dropped from an airplane at 8,000 ft.