How to make a "psi" wheel?

Question

How to make a "psi" wheel?

Answer 1

This is the basic technique to use to learning the Psi wheel,

Making the Psiwheel

1.obtain a tack

2. cut a small square of index card that can balance on the tack...Point to the Psiwheel~making it spin in either direction and stopped when wanted to

How to:Focus on one corner of the paper square. At first it maynot spin.. But as you get used to spinning. Iit is more easier. At first you may not be able to control which way it spins. but soon your should be able to make it spin left or right & make it completly stop.

Answer 2

Try out this site:

http://www.psipog.net/art-introduction-t...

not only you will find out how to make psiwheel you can also make several other psychokinesis exercises.

Answer 3

Here's how:

1) Find some construction paper

2) Draw out a shape consisting of 4 triangles attaches on their sides.

3) Cut out the shape and fold it to make a 4-sided pyramid.

4) On each side of the 4 sides of the pyramid, write one word from this phrase: "I'M WAY TOO GULLIBLE"

5) Balance the pyramid on the point of a pencil so that it spins freely. Concentrate on the wheel and what "I'M WAY TOO GULLIBLE" means. Do this for at least 5 minutes.

6) Crumple up the psi wheel you just made and go do something more productive with your life.

Answer 4

This is one way to make a Psiwheel.

You will need: One piece of paper or tinfoil cut into a 4’’x 4’’ square. One sewing needle. One rubber eraser with flat sides.

Fold the paper or tinfoil in half vertically toward you, top down, then unfold. Fold again but fold horizontally. Unfold. Now your paper or tinfoil will look like it is divided into 4 parts. Flip the paper over. Now diagonally fold in half, making a triangle. Repeat for the other side. Now your paper or tinfoil will look like it is divided into 8 parts.

Stab the needle though the eraser so that when you place the eraser onto a table the needle is pointing towards the ceiling.

Sit the eraser onto a table and place the paper or tinfoil so it balances on top of the needle.