Question:

How to make a ribbon board??

by Guest21428  |  earlier

0 LIKES UnLike

heyy im making a ribbon board and i was wondering how to do it. especially how to make the ribbons tight enough so that the pictures, etc. wont fall through. please help ASAP! thanks!

 Tags:

   Report

1 ANSWERS


  1. Materials:

    Cork bulletin board

    Fabric and batting a bit bigger than the bulletin board

    Gimp ribbon

    Staple gun

    Needle-nose pliers

    Tack hammer

    Glue gun and glue

    Upholstery tacks

    Lay the fabric face down on your work surface, and cover it with a layer of batting. Center the bulletin board face down on the batting.

    Use a staple gun to attach the fabric and batting to the back of the bulletin board. Staple the middle of one side (figure A), then pull the fabric and batting taut and staple the opposite side. Staple alternate sides in this manner. Before stapling the corner fabric, clip off excess batting at the corner so the fabric will lie flat.

    Turn the bulletin board face up, and arrange pieces of gimp ribbon in a crisscross pattern across the front of the board. Pull the ribbon taut, and use upholstery tacks to pin it in place at the edges of the board and at intersection points (figure B). Insert the upholstery tacks by lightly tapping them in place with a tack hammer. If necessary, use needle-nose pliers to hold the tacks while hammering.

    Attach the ends of the ribbon to the back of the bulletin board with hot glue.

    You can place your ribbons closer together to get more pictures on it.

Question Stats

Latest activity: earlier.
This question has 1 answers.

BECOME A GUIDE

Share your knowledge and help people by answering questions.