How to remove s***w from a drill?

Question

I have been using my driller to unscrew some screws off my skateboard, now i need a different size, how do i take the s***w off? sounds kinda dumb 4 me not to know... thanks

Answer 1

Well, both corded cordless drills (has a battery, as Kare...said,) can have either a keyless chuck or a keyed chuck.

What she means to say is if it has a keyless chuck, you twist the upper and lower pieces of the keyless chuck in opposite directions.  Or, if it has  a keyed  chuck, you need the chuck key to insert into the hole of the chuck.  The teeth on the key and the chuck enmesh and allow you to apply torque to tighten or loosen the chuck.

or, heaven forbid, you could use an actual screwdriver and do some actual man's work.

It sounds like you might need some adult supervision.

Answer 2

If it has a battery then twist the front, right by the s***w bit.

if it has a cord then you'll need the "chuck" , a small gear to twist it out (same place).

-to put the new one in just twist it in the opposite direction.