How to reset change oil light on 2002 silveraldo pickup.

Question

How to reset change oil light on 2002 silveraldo pickup.

Answer 1

With Driver Information Center

Turn ignition On, but do not start engine.

Press MODE button until DIC (Driver Information Center) reads OIL LIFE LEFT/HOLD SET TO RESET.

Press and hold SET button until 100 percent is displayed. You will hear 3 chimes and CHANGE ENGINE OIL SOON message will go off.

Turn ignition Off.

______________________________________...

Without Driver Information Center

These models are equipped with an oiling system indicator lamp which will flash if the oil level drops below a safe point or will remain lit when the oil and filter are ready to be changed.

After changing the oil and filter, reset the monitor by proceeding as follows:

Turn ignition On, but do not start engine.

Fully depress and release accelerator pedal three times within five seconds.

If CHANGE ENGINE OIL lamp flashes for five seconds, this indicates system has reset.

Start engine. OIL LIFE should change to 100%.

If CHANGE OIL SOON lamp lights again, repeat reset procedure.

Answer 2

To reset the CHANGE ENGINE OIL message, turn the ignition key to RUN with the engine off. Fully press and release the accelerator pedal three times within five seconds. If the CHANGE ENGINE OIL message flashes for five seconds, the system is reset.

Answer 3

I believe its turn key to run position (that's right before start). pump the accelerator peddle 3 or 4 times I cant remember which it is. Then turn key to run and start vehicle. The check light will flash a couple of times and you will be reset.

Answer 4

theres a button under the hood