I NEED HELP REALL BADLY,PLEASE ITS <span title="ASASP.!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!?">ASASP.!!!!!!!!!!!!!!!!!!!...</span>

Question

I accidently turned my front door key the wrong way and it snapped and half of it is inside the key whole.On the side of the door i was coming in the key whole is diagonal the way u turned it and the other side of the door is normal.I have checked around for screws so i can unscrew it but there none.And only a drop of the key half is sticking out and i cant take it out since the key whole is diagonal .

PLEASE I BEG FOR HELP ON HOW TO TAKE IT OUT.!!!!!!!

Answer 1

There has to be some way to disassemble the lock. Look again on the inside. All hardware holding the lock together will be on the inside. It will be easier to work on after you take it apart. If you can&#039;t figure it out, you&#039;ll have to call a locksmith.

Answer 2

hanger try that

Answer 3

You will need to be sure that the key hole is in the proper position ie straight up and down. See if you can insert the broken part back into the whole and turn it to the right position. If you can do this then you should be able to get the broken piece out. Find the smallest paper clip that you can. Take a pair of needle nose pliers and bend the tiniest hook possible on the end of the clip. Try to insert the hooked clip in under the bottom of the key and start to pull it out.If it starts to come out grab it with a pair of tweezers or the needle nose pliers and ease it on out. It also sounds as if it is a lock that uses a key on both sides of the door? If this is so you still need to turn the outside to the proper position. Once you have it in the proper position you can straighten a large paper clip and push it from the inside through the key hole pushing  the key out. Again use the tweezers on the outside to grab the key and jiggle it out.  

Answer 4

super glue the broken key (not too much because you don&#039;t want to get it stuck to the walls of the cylinder).... put it in there.... wait 30 seconds..... turn it to a position where the key can be removed and hopefully your key comes out whole from the hole

Answer 5

If you can&#039;t free it with needle nose pliers or tweezers, you will need to either try disassembling the lockset from the door to access the lock, or call a locksmith.

Answer 6

Can you use tweezers or pliars to grab what&#039;s sticking out and turn it back and pull it out?

Answer 7

Probably there is a cover on the inside of the door that pops off that covers the screws so that you can remove the lock.  You&#039;ll probably need a screwdriver.  Be careful you don&#039;t damage the surface of the door as you pry against it.

Answer 8

Call a locksmith.  This is probably the only thing to do.