I got two kickers cvr 12's and a kicker 2 channel amp how should i connect them ?

Question

I got two kickers cvr 12's and a kicker 2 channel amp how should i connect them ?

Answer 1

It depends on the nominal impedance.

If they are dual four ohm, Bridge the amp and run the coils in series and the subs in parallel. Giving you a 4 ohm final load.

Or, wire the coils in parallel and run them each off of it's own channel. This will give you a 2 ohm load per speaker.

If they are dual 2 ohm, You 'll have to run them each off of it's own channel. Wire the coils in series for a 4 ohm load per speaker.  

Answer 2

Need more info.  how ohms per coil on the subs(dual 4 or dual 2?)  Which 2ch?  I would venture to say you probably should have gotten a mono amp if possible but still need more info.