I have a 1997 honda civic hx 1.6 L and i want to swap the motor for an H22, what ecu do i need ?

Question

I know there are more parts beside an ecu to complete this swap but i dont know what? can anyone help ?

Answer 1

if i were you i would recomend not getting an H22 swap and go for the GSR (B18c1) or Type R (B18c5) swap...they may be more expensive but well worth it...also you could get the LS swap (B18b) and then get the GSR or Type R v tec head.  it will have better low end response and then with the V tec better top end...also with the LS swap it will be able to handle 12 LBS of boost if you want to turbo it....also the H22 is much heavier and isn't a direct swap as the B series is.

Answer 2

you need the ecu from the same prelude with a v-tech engine,trans,axels, wirering harnes, custom engine mounts, hydrolic to cable trans kit, thats all i can think of from the top of my head right now

Answer 3

If u want it to be emissions legal u will need the OBDII Ecu. U will also need the aftermarket motor mounts and shifts to do your swap. If u buy the whole engine swap you should get the ecu with it. Also make sure it comes with the wiring harness for the engine.

Answer 4

You will need, motor/tranny, motor/tranny mounts, the swap wiring harness for the motor/tranny, shift linkages, axles, ECU, an aftermarket header, aftermarket exhaust, and aftermarket intake, and a way to relocate the fuel filter to the left about 4 inches to accept the position of the throttle body.