I need help with my snowboard?

Question

this weekend my bindings kept coming loose on my board so i tightened them as hard as i coould and now thers bumps on the bottom of my board from the screws i dont know how to fix this should i just have it waxed or somethig please someone help me

Answer 1

There's a type of glue for that you put it on the s***w before you s***w it in, then s***w it in, and or inside the hole and let it dry, it will never come loose again, and you will not have to over tighten it so that bumps come out under the board, you can find it at the hardware store, but make sure it's for your kind of material, like, hardens steel screws to fiberglass, or hard plastic, or whatever your stuff is made of. Also theres lock washers that look like coil springs that you can put between the s***w and the board that will not only lock into place but will not let the s***w go in that much to make that bump. You can even get a tad shorter screws.

Answer 2

1. Thread locker (like Loc-Tite)

2. Use shorter screws - these are obviously too long

3. Have the base repaired and waxed at a shop

Good Luck