I vaccumed my airhockey table,but i still feel that its not blowing enough air the puck doesn't want to move,

Question

I vaccumed my airhockey table,but i still feel that its not blowing enough air the puck doesn't want to move,

Answer 1

Try a wet rag. Wipe it throughly. Make sure it isn't too wet.

Answer 2

You have to find a small wire or small paperclip that will fit the holes and CAREFULLY slide it straight down into each hole to clean it out while the table is turned on. It takes a long time, so while you are doing it have a bunch of pennies so you can put them over hole you have already done so if you take a break an come back you don't have to guess where you left off. If you have enough pennies for one row, then you can move them as you go.

You can also use a straight pin if it is small enough for the holes, but you will have to do it again a lot sooner if you use a straight pin because it just pushes the dust against the sides of the hole instead of punching it down.

Check the bottom of the table where the fan is to see if there is an air filter that needs to be cleaned, dusted, or replaced.

Also, put just a very small amount of turtle wax car polish on a rag. Slip the rag over your finger and carefully rub your finger on the table between the holes, being careful not to get any of the turtle wax on the holes so it doesn't clog them. You can just rub between the rows of holes. This will make the surface slick. After the turtle wax dries for a few minutes wipe it off and buff the table with one of your mom's best towels. On second thought, don't use her best towel because she will ground you.

Also rub some of the turtle wax on the puck.

Good luck! rrr