Iformation on 2001dodge caravan power windows

Question

need ifomation on assembly

Answer 1

you may have to get a repair manual on doing this one because i looked on lone and no -one actually has any pics or much information on showing this job being done,a haynes repair manual will have all the necessary steps in it for doing this one,they give real good instructions for putting one back together,and are the best to use when doing a Job like this one,good luck.

Answer 2

20 Front door window glass - removal and installation.

1 Remove the door trim panel and plastic shield. Remove both inner and outer belt moldings and the radio speaker if installed.

2 Lower the glass so you can get to the front and rear regulator lift plates through the front and rear access holes in the door panel.

3 Remove the clips that hold the door glass to the regulator lift plates and remove the glass from the lift plates.

4 Remove the weatherstrip from the glass and then insert the front of the glass between the glass run and the outer panel.

5 Carefully lift the glass upward and out of the exterioropening at the top of the door.

6 Installation is the reverse of removal.

22 Door window regulator - removal and installation

1  Remove the door trim panel and watershield.

2 Remove the door glass retaining glass and allow the window glass to rest on the bottom of the door.

3 On power window models, unplug the electrical connector.

4 Loosen the screws holding the front and rear guide rails to the door panel/

5 Remove the screws on the guide rails from the key hole slots in the door panel, lift up to detach the regulator, then slide it rearward and remove it through the access hole in the door. Remove the front guide rail through the front access hole and the rear guide rail through the rear access hole.

6 Installation is the reverse of removal.

Hope ths helps, sorry I couldn't include illusrations from the manual. Good Luck and have fun doing it.

Answer 3

its a compleat window regulator and motor assembly....once door panel is off its about 4 bolts and a little wiggling in and out of door panel, cost about 300$