Is satellite cable suitable for freeview signals?

Question

I recently acquired some coax, it is RG6 satellite cable, 75 ohm and semi air spaced. If you look at the link below, it is type 532B:

www.detaelectrical.com/catalogue/107.h...

I am getting a new TV aerial put on my chimney and was wondering if this cable would be suitable to use? Can it be used for freeview and digital signals? Will it work for the HD signals when they come on freeview next year?

Thankyou in advance

Answer 1

Yes Rg6 is the coax cable out there. But the cable is only as good as the end so make sure you buy good end either Bestbuy , lowes or other electronic stores

Answer 2

Yes, it's better than low loss co-ax, but don't go overboard with it. I'd recommend the RG6 type rather than the CT100.

If you want technical details, low loss co-ax on a 15 metre run will give an attenuation of 4dB, RG6 about 3, and CT100 2.5. 6 dB is about half the signal. You'll need to terminate in a Belling-Lee connector rather than an F-plug.

CT100 currently sells at between £1 30 and £1 60 a metre, RG6 a bit cheaper, and both will be fine for HD.

Answer 3

Yes this will work with your new antenna.

Any 75 Ohm coax will do, RG6 has a lower loss in relation to normal domestic cabling normally used.

The same antenna & cabling will most likley be able to pick up the new digital services when your area is upgraded in the next few years. If your are in a weak reception area you may need a larger antenna for digital. If you look on the freeview website they will be able to advise better on your location.