Is there a way to make a twin bed connector?

Question

I live in a dorm room by myself and I like to connect my twin beds. Last year, I could barely stand the crack in the middle. I have tried to look up those connectors you use to put two twin beds together but everything that pops up is pretty expensive for me. Is there a way I can make a connector? I have a king size mattress pad to cover the bed and it does not help at all with the crack in the middle. Thanks for any advice!

Answer 1

Turn frames so that space gos across (left to right) instead of top to bottom then lay mattress on them

Answer 2

Try this:

1) Cut a rectangular piece of board so it is the same length as your bed, and the width reaches from the floor to about 2 inches below the mattress level.

2) Roll dense fabric into a tube, and stuff it between the two mattresses, so it rests on top of the board.

3) Put a layer of foam rubber across both mattresses, followed by a large mattress pad, and finally a sheet.

You'll probably detect the part between the mattresses, but at least it will soft and support your weight.