Making a f******n restoration device

Question

i've been doing some research on f******n restoration. but i can not seem to find any websites that give free step by step instructions to make your own f******n restoration device. does anyone know of a good website with different types along with free instructions on making your own?

Answer 1

What I've seen as a good starter (if you have little slack) is to take a film canister, cut a disc in the top (save the bit you cut out). Then take a butterfly paperclip and remove the thumb levers. Fit the levers through so it looks like a crude cone device (like on TLCTugger.com). Then punch a small hole in the middle of the disc for airflow, and insert it into the canister and heat up a long pin until it's redhot (use potholders to handle the pin), then use this to melt the disc back in place, holding the thumb levers in place.

Then insert the head of your p***s into the canister, roll some skin onto the canister, and use paper tape (you can get it at almost any drug store) to hold the skin in place. Put on a knee brace, and take a suspender strap, attach one end to the thumb lever and the other to the knee brace (for longer straps or penises, you will have to loop strap around the knee. The tension will promote new skin growth.

After several weeks or even months, you should have enough skin to use something the size and shape of a shooter marble to shape growing f******n. I'm working on finding something the right size and shape that can have something affixed to it for tugging. Will post if/when I find it.

I hope this is enough to get you started.