Maytag top loader washer wont spin, any common problems?

Question

maytag top loader, model mavt546eww, wont spin, visually inspected, no hoses kinked or bound, brake is applied so i cant tell how it feels to turn, are there any common transmission problems, this thing is only a couple of years old with light use

Answer 1

Have you checked the lid switch.  If the lid is not closed the washer will not pump out or spin.  Look for the plastic pin on the lid and then check the hole it goes into.  Take a screwdriver or a plastic straw and insert it into the hole most of the time you can hear the switch click.  If it clicks it is most likely working but it could have come loose and not being pressed by the lid pin or a wire could have come off the switch.

Good Luck

Answer 2

I BET your transmission/motor coupling has broken - plastic (an easy fix) part is about 5 bucks. Check out this link to fix...TIP you don't have to take off the washer's housing. Just tip it on its back (maybe on some towels so it doesn't scratch the floor/paint

http://www.cheapapplianceparts.com/repai...

Good Luck and let me know!

Answer 3

First check for pump failure. The pumps bearing will separate and lock up on this model.

Next will be the thrust bearing. A worn thrust bearing is easy to replace and in expensive. The motor on this model is reversing. When it goes one way, it washs the clothes and the water stays put. When it spins the motor turns in the opposite direction and releases the brake, allows the pump to kick the water out. If the thrust bearing wears then it won't allow the brake to release. Of course if the lid switch is bad then the washer won't spin either.

Answer 4

Drive belt probably broke. If you have your manual handy, check for it's location, and take off the panel and visually inspect the belt. If it is that, call an appliance repair shop and have them order you a belt. Go to the link below for directions on how to change it. http://www.acmehowto.com/howto/appliance...