My chainsaw cover plate won't reinstall?

Question

I replaced a chain on my Husqvarna. I have done this before without a problem. The cover plate won't rest flush/flat on the saw. After an hour of looking, at different angles, I can't figure out what the problem is!

Answer 1

sounds like something is still raised and or not seated properly, as these covers are pretty user friendly.

Good Luck

ROSCoooooooooooooooooooooooooooo

Answer 2

You'll either have to describe it in greater detail or take a picture and post it so we can figure it out.  Obviously there is something blocking the holes, the cover, the saw or something.  You just need to share in a little greater depth.

Answer 3

get a chainsaw

Answer 4

aaeon is right. I had the same problem and it drove me nuts until a friend of mine showed me the problem.

Answer 5

The chain adjustment cog is screwed too far forward (tight).  Adjust the chain looser and the cover will go right on.  Take a look at the cog/pin moving when you s***w the adjuster, now see the hole in the cover plate?  Once it's on, adjust the chain properly, of course.

Good luck!