My pool stick is bent how do i fix it?

Question

the middle where it screws together had a plastic bearing like thing around it its like at a slant i think a grip would work not sure

Answer 1

I'm not real sure what you mean. If your talking about one of the sleeves at the joint it can probably be replaced pretty easily by a good repairman. If you mean a warped shaft just throw it away or use it for firewood. Go to a cue maker or your cues manufacturer and have a new one made.It's a lot cheaper than buying a whole new cue. That is provided you have a decent cue and not a wally world special.

Answer 2

"Chalk" it up to experience and just get a new one!

Answer 3

Well depending on what kind of cue it is you might be able to have it fixed, or call the cue company if it was by natural causes because that shouldn't happen.  To see if you just need a new shaft take it off and roll the butt end on a flat surface like a pool table and if the joint pin (s***w part) doesn't wobble while rolling it you know its the shaft.  If it does you'll need to look into a new cue or maybe its under warranty.  I would also say if you are serious about pool and have the means, do not buy a cue at wal mart.  You get what you pay for, and that would be junk.  Good luck and keep rackn em up!

Answer 4

Call Harendra.

91-9979288816

Answer 5

sorry you dont you go to wal mart and buy a new one

Answer 6

You need to make friends with the guy you hit with it so thaty you can reshape it again using his head.

Answer 7

Take it to a pro to see if it can be fixed....once it is bent though the best thing to do is buy a new cue...buy a decent one and it shouldn't bend.  You need to buy a good quality cue.